RedHead Steering Gear Box. Some original housings are manufactured without bushing or bearings. This is commonly seen in some Ford steering gears and Chrysler steering gears. We rebore these units and install needle bearings.

We use only the highest quality seals. All our seals are either O.E.M. or produced by two high quality, long time suppliers of our industry.

Probably the most unique and important thing we do is custom fit every single worm and piston assembly with new precision fit steel balls. This is a process not matched by any other company in the industry. This process is very important. The machining tolerances of the original manufacturing leave a small and varying amount of play that can not be corrected in any other way.

**Special Notes: Be sure to do a spline peak count of your output or sector shaft, which indirectly connects to the tires, you should have a total of 36 splines. (Please view the third picture on the left, you will see you have 9 spline peaks between each master spline, and there is 4 master splines, so 9 times 4 = 36 splines)

If you have a 32 spline sector shaft, please order Part#: 2764



Specs:
Weight- 30.00 lb(s)
Ratio- 18:1 / 4 Turns
Input- Single flat with 27 splines
Output- 36 Spline Sector 4 Master Spline
Fittings- O-Ring